GLTC Champion & Runner Up || BTW

On today’s podcast, Luis and Rich are joined with GLTC champion Tom O’Gorman and runner up Andy Smedegard! The ASM guys absolutely killed it this season with FIVE people finishing in the top ten in GLTC. We get to talk with them about the season and what is the driving force behind this unstoppable machine of ASMotorsports.

Thank you for Tuning in and please, if you like the podcast and what we’ve been doing here, please SUBSCRIBE! We’re on iTunes, Spotify, Stitcher and we always put the full video interviews on our YouTube Channel (https://www.youtube.com/konigwheels)

(we’d love if you subscribe there as well!) Thank you for listening!

 

FOLLOW:

For more on ASMotorsports:
ASM’s Instagram: ► @asmotorsports.us
Andy’s Instagram: ► @dizmm
Tom’s Instagram: ► @tomoracing
ASM’s YouTube: ► https://www.youtube.com/andysmede

Konig’s Instagram: @konigwheelsusa

More on the Konig Behind The Wheel Podcast and to SUBSCRIBE:
https://konigwheels.compodcast

Play

NTSB To Enforce Speed Limiters?

Recently the NTSB (National Transportation Safety Board) has made a recommendation to car manufacturers to implement speed limiters in their vehicles. This is not entirely new as there are vehicles out now that have this technology already. This technology would prevent vehicles from surpassing the speed limit of the road that you are driving on. Once you reach the top of the limit, the accelerator would cease to send power.

I saw a video with a Chevy in it that had this technology and the car had a button you could press that would allow the car to exceed limitations for a duration of 15 seconds (for merging or passing I assume.) Looking at this from two angles, I think it makes sense and it doesn’t make sense. If you have a rather simple daily commute, I can see a speed limiter with an option to speed for a little as not too much of an issue. However, even when implementing this into a vehicle the maker understood that capping the car to the speed limit is too restrictive which is why they would even put that boost button in there in the first place.

Safety should always be a priority but there are many things that are sold to the average person that can be unsafe or result in injury or worse. You can make the argument that something like kitchen knives are dangerous if used improperly. You can make the argument that a ladder can be dangerous and accidents may occur. I think the main differences between vehicle accidents and the examples above would be that if you wanted to hurt someone else with a kitchen knife that is a decision not an accident. If you hurt yourself with a kitchen knife by accident it doesn’t affect someone else. If you had an accident on a ladder you yourself would fall and get injured. The problem with vehicles is that even if you make a mistake and cause an accident you can affect other people without intentionally doing so.

I am not advocating for the use of the limiters, however I do think there should be other ways to go about ensuring safer roads for people. I think driving tests should be a recurring test where someone would have to pass it periodically in order to keep a valid license. That would be an easy way to weed out unfit drivers regardless of what kind of hinderance they may be experiencing. Thanks for reading.

-Rich, Konig Wheels

For more on this topic, check out our last podcast:

… Also, available in audio on Spotify, iTunes, Amazon, Stitcher, iHeartRadio.

Enforced Speed Limiter? || BTW

On today’s podcast, Luis and Rich talk about a recent recommendation by the NTSB to car manufacturers to put speed limiters in passenger vehicles. This is something that has only been recommended but there are already vehicles that follow this technology. Is this something that you think should be implemented or does it cause a bigger problem? Let us know what you think!

Thank you for Tuning in and please, if you like the podcast and what we’ve been doing here, please SUBSCRIBE! We’re on iTunes, Spotify, Stitcher and we always put the full video interviews on our YouTube Channel (https://www.youtube.com/konigwheels)

(we’d love if you subscribe there as well!) Thank you for listening!

 

FOLLOW:

Konig’s Instagram: @konigwheelsusa

More on the Konig Behind The Wheel Podcast and to SUBSCRIBE:
https://konigwheels.compodcast

Play

Stock Exhaust Is Too Loud?

If you have not heard, there is an ongoing case in California of an owner of a 2022 Hyundai Elantra N that is stuck in between a rock and hard place. The incident that happened is that the owner and driver of this car was pulled over by local police in the state of California. The officer stated that the car’s exhaust is backfiring and is too loud. The driver informed the officer that the car was stock and has been unmodified and offered to let the officer to check under the hood. The officer declined to look under the hood of the vehicle. The officer then went on a tangent on how the driver will have to bring the car to the state ref where they will suspend the registration of the vehicle and he will then have to go back to his Hyundai dealership to have “track” mode taken off the car at his expense and finally going back to the state ref to prove that “repairs” were done. The officer stated that all of this would cost the owner roughly $7,000.

Yikes. After dash cam footage of this incident hit the internet it went viral. Here are my personal takes on this situation. First and foremost, the owner of the car handled himself and the situation very well with much respect. I feel that the officer was far too quick to pass the buck over to another department and tell the young man on how the outcome would be like he has already sent over every other Elantra N in his area to the state ref. Unfortunately there was a lot of fear and confusion instilled and not any suggestions on how to get it resolved, he only stated consequences.

As far as the owner of the car, I personally don’t think he took the best course of action to make this as little of a headache as possible (this is all speculation and keep in mind I am not from California.) I am assuming this young man went to the state ref and told them everything that happened, which is not something I think I would have done. I would have probably went to the state ref and said something along the lines of, “I have a brand new car and got a ticket that my car is too loud. My car is completely stock and has never been modified. Go ahead and inspect it and I’ll be on my way to fight this citation.” Unfortunately what I assume what happened is that the owner told the entirety of the situation to the state ref including that the car has different drive modes along with everything the officer said. They proceeded to inspect the car in “sport” mode which from my interpretation is not mandatory. The car ultimately failed the decibel test. The owners registration has been suspended and going on 3+ weeks of not being able to drive his vehicle.

This all may seem a bit ridiculous but truthfully this is not and cannot be the first time something like this has happened. Think about all of the supercars in the state of California that are far louder than a 4 cylinder Hyundai. Auto manufacturers know the law and comply with regulations. Hyundai should have provided this young man with some kind of validation that he needs to get himself out of this jam. I am not talking about his local dealership, I’m talking corporate Hyundai. The fact that they are taking so long to help resolve this issue is beyond me. If I was looking into a new sports car I would be fearful that I would run into similar issues when purchasing a new N vehicle. I would also be fearful if I already owned one of the vehicles that this may happen to me. It is a shame because the variable exhaust system may be the coolest feature about the N vehicles. Those are my thoughts on this situation. Thanks for reading!

Rich – Konig Wheels

Stock Is Too Loud || BTW

On today’s podcast, Luis and Rich speak about an ongoing case in the automotive industry where someone has been fined $7,000 for driving around in a STOCK 2022 Hyundai Elantra N. This case is getting a lot of attention in the automotive world and you can tune in to hear our opinions about the situation. Let us know what you think!

Thank you for Tuning in and please, if you like the podcast and what we’ve been doing here, please SUBSCRIBE! We’re on iTunes, Spotify, Stitcher and we always put the full video interviews on our YouTube Channel (https://www.youtube.com/konigwheels)

(we’d love if you subscribe there as well!) Thank you for listening!

 

FOLLOW:

Konig’s Instagram: @konigwheelsusa

More on the Konig Behind The Wheel Podcast and to SUBSCRIBE:
https://konigwheels.compodcast

Play

Konig Hypergram | Flow Formed

The Konig Hypergram is one of our most popular wheels in general. Coming in four finishes with a huge range of sizes, pcd offerings, and offsets. This wheel is iconic to our brand and does it all. It is a flow formed wheel making it extremely light weight and durable while still being visually pleasing.

The Hypergram has been introduced in a Matte Black finish along side the Matte Grey, Race Bronze, and Carbon w/ Machined Lip. The Hypergram comes in 4 & 5 lug bolt patterns with widths up to 11 inches and newly introduced 19 inch diameter. To see more specs click the button below.

Specs and sizes

 


FOLLOW:

Konig’s Instagram: @konigwheelsusa

Konig’s YouTube: https://www.youtube.com/konigwheels